AWS 924-948 - Solid State Logic

DAW ControlHUI AUTOMATIONThe AWS’s touch sensitive moving faders can be used to write automation for the DAW fader. Most automation functionscan be enabled from the soft key matrix below the console’s display screen. Within this are menus for Automation Enables,Automation Modes, Grouping and Editing functions.A-FADA, which uses DAW automation to control analogue faders, is descibed on Page 4-7.Note: Automation data can usually only be written when the DAW is in Play, Half-Speed Play or Record.Automation EnablesAutomation Enable modes (AuEn) globally engage or disengage automation for the following items: Faders, Pans, Plug-Ins,Cuts (Mute), Sends and Send Muting (SnMute). Holding down the OPTION button then pressing any of the sub menubuttons will toggle automation on or off for all controls.The Pan automation enable includes both Channel and Send Pan.Automation ModesThere are several Automation Modes (AuMo) available including: Write, Touch, Latch, Trim, Read and Off.To change automation mode on a channel select an automation mode from the soft key menu and press the auto buttonon a channel fader. Holding down OPTION then selecting an automation mode from below the TFT screen will changeautomation modes on all channels. Changes within the DAW will be reflected on the console.Refer to your DAW manual for more information on its specific automation features.Automation Status DisplayPressing and holding the auto button to the left of a channel fader will display the currentautomation mode for that channel in the channel scribble strip display. To display the automationmode on all channels select the Status Group (StGr) soft menu, and press Auto.The automation LED indications are as follows:No LEDAutomation offGreen LED Read automation modeRed Flashing LED DAW is ready to write automation in write, touch or latch modes.Red solid LED Writing automation dataRed and Green LEDs Trim automation modeAWS 924-948 Owner’s Manual Page 4-29