ISDN Protocol Administrator's and Developer's Guide ... - Intervoice

Defining the ISDNTKIT Toolkit SubroutinesThe parameters included on theSET_AND_SEND_CONNECTED_NUMBER_ELEMENT form aredescribed in Table 4-42.Table 4-42. SET_AND_SEND_CONNECTED_NUMBER_ELEMENT ParametersNumber Parameter Required? Type Description1 Line Number Yes Integer Identifies the application or outbound linenumber if connect.dll is being used and thiselement should be included in the Setupmessage.2 Which Message Yes Integer Identifies the type of message in which theSET_AND_SEND_ CONNECTED_NUMBERelement are included.Valid range and types:• 0 – Do Not Send This Message• 1 – Setup Message• 2 – Disconnect Message• 3 – Facility Message3 Type of Number Yes Integer Identifies the number type that is included inthe SET_AND_SEND_CONNECTED_NUMBER element.Valid range and types:• 0 – Unknown• 1 – International (Call from outside theimmediate country)• 2 – National (Country-specific domesticcall)• 4 – Subscriber4 Numbering Plan Yes Integer Identifies the numbering plan that is includedin the SET_AND _SEND_CONNECTED_NUMBER element.Valid range and types:• 0 – Unknown Numbering Plan• 1 – ISDN/Telephony Numbering Plan• 9 – Private Numbering Plan60001262, First Edition Common Subroutines for the ISDN Toolkit 4-77