ISDN Protocol Administrator's and Developer's Guide ... - Intervoice

Defining the DMS SubroutinesGET_RLT_SETUP_RESULTThe GET_RLT_SETUP_RESULT subroutine is used to obtain the result ofan ISDN_DMS_SETUP_RLT_XFER call returned from the switch. IT isnot called by the application.For more information onconnect.dll and itsUserDLL functions, referto the Call TransferOptions Administrator’sand Developer’s Guide.After an outbound call is made, the switch sends either an Alerting or aProgress message with a ROSE (Result of Outbound Setup) Element.The ROSE element indicates the result of the request that was sent in theOutbound Setup Message. GET_RLT_SETUP_RESULT waits and gets theROSE element. If a failure occurs before the toolkit obtains the element,the GET_RLT_SETUP_RESULT should be discontinued.A sample UserSubroutineCall form that callsGET_RLT_SETUP_RESULT is shown below.Parameters:See Table 11-6.Table 11-6. GET_RLT_SETUP_RESULT ParametersName Required? Type DescriptionOutboundLineYes Integer The outbound linenumber60001262, First Edition DMS ISDN Protocol 11-11