ISDN Protocol Administrator's and Developer's Guide ... - Intervoice

T444Starts after the receipt of a Disconnect message. This timer iscleared if the application sends down a Hang command, causing aRelease message to be sent out. If this timer expires before theapplication can send a Hang command, a Release message is stillsent to keep the line from entering an error condition. The range is 1to 600 seconds.To back up to the System Configuration menu, press . To back upto the General Menu, press again. To save a change to the FrameLevel Address parameter, press .B ChannelConfigurationTo configure the B Channel:1 Enter 2 at the System Configuration screen.Pressing aftermaking a selection is notnecessary.2 Select the span to be configured by choosing a number from 1 to 8,and entering it in 01 format.3 Select the B channel number by choosing a number from 1 to 23 forT1, and 1 to 30 for E1.4 The BCCB Configuration screen appears.The BCCB Configuration screen for the B Channel is describedbelow:Span NumberIndicates the span that was chosen by the user in step 2 above.Bearer ChannelIndicates the B Channel that was chosen by the user in step 3above.14-10 ISDN Protocol Administrator’s and Developer’s Guide 60001262, First Edition