TOTAL STATION InstructIon manual

Closed traverseOpen traverseThe following assumptions are made:The current station is the foresight point of the previous station which you select as anext station. The back sight point of current station is the previous station.The following limitations are made:More than one traverse route can’t be measured at the same time. Don’t store other datawhile you are measuring the traverse route. When one traverse route is finished, performthe traverse calculation before you store other data. Don’t turn the power supply ofuntil the measurement at one start point or at one corner point is completed.Don’t escape from the MEASURE screen.You can’t use a duplicate PN in one Job. And you can’t overwrite the PN in the traverse.The same traverse route can’t be calculated again. Polar coordinates data of back sightand station points can’t be seen in the EDIT THE POLAR DATA function. But it is sentproperly in SEND POLAR DATA function.TraverseFrom the PowerTopoLite, Press the [F1][TRAV] of the PowerTopoLite to view theTRAVERSE screen.99