TOTAL STATION InstructIon manual

For seting “Type of Device” in the “Setings” panel (Menu—“Edit”--”Setings”),select “R-100(PTL) / R-300(PTL)” for “R-300 PowerTopoLite” and other seting should be asfollows.Please note that these settings should be common with R-400's. And if theselection of “Type of Device” is not corect it may result in mising some data.R-400 → PC(DL-01)Bits per second: 1200 (1200-9600 for sending “POLAR DATA”)Databits: 8Parity:NoneStop bits: 1PC(DL-01) → R-400Bits per second: 1200Databits: 8Parity:NoneStop bits: 1c) Note for the Memory capacity.Data transfer failure from DL-01 to R-400 may cause reduction of memory capacity.If memory capacity becomes less, please back up required data first, and then initializecoordinates data.To initialize coordinates data, turn on the instrument while pressing [F2]+[F5]+[ON/OFF],and take your finger off from [ON/OFF] again.After you see the mesage “COORD. DATA INITIAL”, pres [F5]. Then the mesage“Please wait” is displayed. When it is completed, the panel of Electronic Vial is displayed.130