TOTAL STATION InstructIon manual

• Thenumber of data exceeds the maximum number of job files stored in the internalmemory.If the total number of points in all job files exceeds the maximum number of points storedin the internal memory, an error message [WARNING This job file was exceeded] isdisplayed.(6000 points for R-422N and R-423N, 5000 points for R-425N,R-435N and R-415N).In this case, up to the maximum number can be read, but after that no more.[Suitability of SD card]• The SD card that can be used with the instrument is 1GB or less.• SD card and SD logo is registered trademark.• The SD cards listed in the following table have been tested by us andit has been confirmed that the SD cards can be used with the R-400 series.This test has been done with only the Pentax R-400 series Total Station, but no other PentaxTotal Stations. When using with other Pentax Total Stations, please contact us to confirmit works properly.It has also been confirmed that the models mentioned in the following table can be used withthe R-400 series Total Station. Other brands or models of SD cards are not confirmed by us.Please note that the test has been done by us and that this does not mean that each SD cardmanufacturer guarantees that the SD cards can be used with the Pentax R-400 series.SD(micro SD)CardMaker Model CapacityToshiba SD-C01GTR 1GBToshiba SD-MD001GA(microSD) 1GBPanasonic RP-SDM01GL1A 1GBMake sure to use the adaptor when using a microSD.• Regardless of the information mentioned here, take note that not all SDHC cards can beused with the R-400 Total Stations.• Test item:The following has been done according to our Test Standards.1 When data is being sent (by connecting USB), it is necessary to be able to refer toinformation on the SD card from PC and to operate the file.2 When writing/reading text, it is necessary to be able to read/write text file.119