TOTAL STATION InstructIon manual

12. ROAD DESIGNYou can use this function to calculate basic design clothoid, raised type clothoid,and central peg and width peg of simple curve, and record the coordinates byinputting and specifying each coordinate of BP,IP and EP and the elements of thecurve.WARNING• Road calculation excludes Z coordinate values from the calculation.• Road calculation allows you to calculate up to 3,000 points in combination with numberpeg, plus peg and width peg.• The maximum number of points that can be processed per route is 3,000 points. Whenmaking a design for a complex route having many consecutive IP points, you may not beable to obtain your desired smooth linear shape if you calculate with an extreme and roughpitch. Also if there is a mistake of inputting coordinates or elements, it may generatethe coordinates quite differently from your desired linear shape. To prevent yourself fromthese, we recommend you to send the generated coordinates to PC and confirm the linearshape on the monitor or printer screen before using.[Measurement point name to be selected and specified]Regarding measurement point name of each coordinate, input alphanumeric character upto three character following the character of BP, IP and EP. When more than three charactersfollowing BP, IP and EP or completely different alphanumeric characters by deleting theinitial character are input, it automatically generates the point name of an existing value.This will also happen when you specify a coordinate by researching from the memory.[Generation of measurement point name]Numerical part: 3 digits and up to 001~999.Integer part of plus peg: up to 01~99.Width peg: Left width peg [L] is added at the end of the measurement point name.Right width peg[R] is added at the end of the measurement point name.NOTE: measurement point name is not processed for the additional distance.107