TOTAL STATION InstructIon manual

4. MEASUREOffset3.Rotated planeReference P. Coordinates1.Cylinder faceRemoteBacksight P. Coordinates2.Fixed planeAzimuthStation Point CoordinatesAn operator can measure the Foresight point Coordinates from the “Station pointCoordinates and Backsight Coordinates” or the “Station point Coordinates and Azimuth”,and can store the Point Name and measured Coordinates in the memory. When theCoordinates of the Station point and Backsight point are already stored in the memory, thenew Coordinates input can be omitted by calling or searching from the point name LIST.The Point Name is within 15 characters and the Coordinates are within 8 in integer and3 in decimal number. There are two Coordinates types: Rectangular and PolarCoordinates in this [MEASURE].The Offset at the Target point measurement is possible and the Remote measurement, byaiming at any point, is possible as well when you select the Rectangular Coordinates.An operator can perform the [MEASURE] function only when the Telescope is at the“Face left position”.Select the Target type before performing the [MEASURE].After measuring rectangular coordinates by [MEASURE] function of PowerTopoLite,it is possible to display Angle and Distance by switching the [F3][ANG&DIST] key.When Remote mode is selected, Angle and Distance are also calculated according tothe Coordinates of the aiming point on real time.When offset mode is selected, Angle and Distance are also calculated according to theCoordinates where offset value is added.18