TOTAL STATION InstructIon manual

Press [ENT] to open the Z coordinate input screenand input.Only in the case of fixed traverse, end pointcoordinates setup screen is displayed.(Input the PN, Coordinates and PC of the End point.)After Z coordinate input, END POINT COORD.SETUP screen is viewed.Input the PN, X, Y, Z Coordinates and PC name ofthe End point.Press [ENT] to view the RESULT COORD. OFTRAVERSE screen.Display of Calculation Results ※The contents of“e/S”varies by the points to be displayed.Points being displayedContents of“e/S”Traverse point of Station Point Length between last station P. & current P.(The point where the instrument is/ Length between start P. & current P.set)Traverse point of not Station Point Length between last station P. & current P.(The point where the instrument isnot set)Start PointClosing errors / Total lengthEnd Point Length between last station P. & current P./ Length between start P. & current P.※In case of OPEN CALC, Closing errors is not available.[F1] and [F2] only indicate corner points in order.[F3] and [F4] indicate all points in order.e/SPress [F5][ACCEPT] to save the all corner, sideshot points, and known points.105