TOTAL STATION InstructIon manual

4.2 Station OrientationPress the [F5][ACCEPT] to view the STATIONPOINT H.ANGLE SETUP screen.Please note, that the rotation of the “H.angle”depends on the rotation setting of“Coordinate axis definition”.Input the H.angle by pressing [F2][INPUT], [F3][0SET] and [F4][HOLD] or Reference pointCoordinates by pressing [F5][BSP].•[INPUT] KeyEnter any horizontal angle.Press [ENT] to view the BSP SETUP screen.•[BSP] KeyThe Back Sight Point information is obtained.Press [ENT] to finalize input.Press [ENT] or [F5][ACCEPT] to view the AIMAT THE REFERENCE POINT screen.Press [F5][ENT] to finalize BSP.Press [F1][ESC] to redo input.If you want to make measure to checkthe point to be aimed, press [F3][MEAS]to display MEASURE screen.Press [F1][MEAS] to make the distancemeasurement. DESIGN DISPLAY screenappears when the distance measurement is done.Compare design value with measured value.When“PREFERENCE”of“12. BOTH FACES MEAS”is on,measure the distance at the normal and reverse position.The measured value to be displayed is the average of measured values measured in normaland reverse position.23