PC3000 Complete Installation guide iss 12 - Elektro-Trading

PC3000 - Installation Guide iss. 5
4 Channel Analogue Output Module
(6) Enter the required output value for a requested output of Tr_Cal_Hi_P. As the
example given earlier, if it is required that the output is trimmed to produce
100.2% at full scale, enter 100.2 via the parameter, Tr_Cal_Hi_V. The analogue
ouput will take on this value.
(7) Change the parameter Cal_Mode from TCal_Hi to Run in order to store the new
calibration data.
(8) In the event of an error occuring whilst calibrating e.g.entering the wrong value
for the desired output level, simply re-enter the value via Tr_Cal_Hi_V or
Tr_Cal_Lo_V.
10-9