PC3000 Complete Installation guide iss 12 - Elektro-Trading
PC3000 Complete Installation guide iss 12 - Elektro-Trading
PC3000 Complete Installation guide iss 12 - Elektro-Trading
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Rack Interface Module<br />
Removing the metal sleeve<br />
7-4<br />
Caution<br />
The module contains static sensitive components and care must be<br />
taken to ensure that the surface onto which the printed circuit board<br />
assemblies are to be placed and the user are at the same potential.<br />
Standard anti-static precautions should be observed.<br />
If full anti-static precautions can not be observed, personal grounding<br />
may be achieved by touching an earthed metal chassis or component<br />
prior to handling the module.<br />
The metal sleeve must be removed in order to gain access to the motherboard.<br />
(1) Remove the M3 screw and shakeproof washer which retains the printed<br />
circuit board earthing block to the sleeve, from the lower left hand side of<br />
the metal sleeve.<br />
(2) Loosen the two M2.5 nuts retaining the backplane end of the motherboard<br />
to the sleeve.<br />
(3) Slide the motherboard out of the metal sleeve towards the back of the<br />
sleeve.<br />
(4) Fitment is the reversal of the process. However, care should be taken to<br />
ensure that the motherboard is located correctly within the metal tabs (earlier<br />
versions only) inside the sleeve before tightening any fixing.<br />
FRONT<br />
Extension Rack<br />
Communications<br />
Connector<br />
PCB Earth<br />
Block and<br />
M3 Screw<br />
Bottom of RIM Sleeve<br />
Earth Clip Contact<br />
Module Guide<br />
Backplane Connector<br />
Printed Circuit Board<br />
M2.5 PCB to Sleeve<br />
Retaining Nut<br />
<strong>PC3000</strong> - <strong>Installation</strong> Guide