PC3000 Complete Installation guide iss 12 - Elektro-Trading

BEFORE YOU BEGIN
Before installing the PC3000 system hardware ensure that:
• All modules are of the correct type for the application.
Check advice note and/or module label for module identities.
PC3000 Installation Guide
Introduction
• The Local Controller Module is fitted with the correct version of system
firmware and that it is compatible with the associated Function Block
Library in the PC based Programming Station.
Refer to Chapter 5 LCM for compatability details.
Refer to Chapter 6 LCM-Plus for compatability details.
• The location and wiring requirements for each module is understood.
Refer to the chapters covering installation for each of the system
hardware components.
Unpacking the system
All PC3000 racks and modules are packaged in shipping containers designed to
withstand reasonable transit shocks. It is suggested that each item be unpacked
carefully and the contents inspected for damage. The original packaging should be
retained if re-shipment is required.
If there is evidence of shipping damage, please notify Eurotherm or the carrier within
72 hours. The packaging should be retained for inspection by a Eurotherm representative
and/or carrier.
All packaging contains anti-static materials to prevent the build up of static which
can damage electronic assemblies.
Unpacking the rack
The PC3000 rack packaging includes an insert intended to retain the card guides
during transit. The rack fascia should be removed and the polystyrene insert removed
from the rack and discarded unless re-shipment is required.
1-1