PC3000 Complete Installation guide iss 12 - Elektro-Trading
PC3000 Complete Installation guide iss 12 - Elektro-Trading
PC3000 Complete Installation guide iss 12 - Elektro-Trading
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The Power Supply<br />
4-6<br />
Link 2 selects the mode of operation.<br />
LK1<br />
LK2<br />
NO 'HOLDOFF'<br />
'HOLDOFF' for 1s<br />
The module is supplied with the link fitted in the 'NO HOLDOFF' position.<br />
Setting the watchdog relay snubber protection<br />
A resistor-capacitor combination is<br />
provided for contact protection. It may<br />
be connected across normally open or<br />
closed contacts. Link 1 selects the position.<br />
The snubber is connected across the<br />
normally open contact when the link is<br />
fitted in the position closest to the front of the pcb.<br />
LK1<br />
Snubber<br />
Protection Link<br />
Fuse replacement<br />
The only maintenance operation possible on<br />
Fuse<br />
the <strong>PC3000</strong> Power Supply is fuse replacement.<br />
The fuse is located on the printed circuit board.<br />
To gain access the module must be removed from<br />
the rack as described previously. The fuse may be<br />
accessed through the side of the modules’ metal sleeve.<br />
A suitable replacement fuse is a glass 20mm, 1.6A time lag type (EN60<strong>12</strong>7 type T)<br />
(Eurotherm part number:CH510162).<br />
N/O<br />
N/C<br />
<strong>PC3000</strong> <strong>Installation</strong>
Change language