Applied Biosystems SOLiD™ 4 System SETS Software User Guide ...

Set up Multiplexing run in ICS
Create a Fragment
and Paired-End
Multiplexing run in
ICS
Assign Libraries in
ICS
Applied Biosystems SOLiD 4 System SETS Software User Guide
Chapter 6 Support Multiplexing
Set up Multiplexing run in ICS 6
There are two ways to set up a multiplexing run in the ICS:
Creating a multiplexing run using the Run Wizard
Importing a multiplexing run
Note: Refer to the Applied Biosystems SOLiD 4 System ICS
Software Help or Applied Biosystems SOLiD 4 System
Instrument Operation Guide (PN 4448379) for detailed
instructions on these procedures.
Continuing in the Run Wizard, you manually configure each barcode
library to generate a new run definition. You need to save the run
definition before you assign the run to one of the two flowcells.
Using the Run Wizard, assign libraries to the appropriate barcode
from the appropriate multiplexing series by creating a run definition
file.
Note: Refer to the Applied Biosystems SOLiD 4 System ICS
Software Help or Applied Biosystems SOLiD 4 System Library
Preparation Guide (4445673) for detailed instructions on these
procedures.
107