OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER
OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER
OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
290<br />
(a) With the control selector lever in the "Electrical"<br />
position, the latch on the operator's<br />
control shaft is to be held out <strong>of</strong> its notch,<br />
and is to clear the cam when the operator's<br />
control lever is moved to either the "Hoist"<br />
or the "Lower" position. With the control<br />
selector lever in the "Mechanical" position,<br />
the latch on the operator's control shaft is<br />
to drop into the notch on the latch cam,when<br />
the operator's control lever is in the neutral<br />
position.<br />
The next step is to adjust the adjustable rods to provide for<br />
the correct angular position <strong>of</strong> the control selector levers<br />
at the A-end (see 274239, installation - A-end), as follows:-<br />
(b) To adjust the brake release valve lever .. :-<br />
. (1) The control selector lever is to be in the<br />
"Electrical" control position.<br />
(2) The brake release valve lever is to be placed<br />
in the "Electrical'! control posi tion -a s shown<br />
on the installation drawing <strong>of</strong> the A-end<br />
(see 274239)~ The correct position <strong>of</strong> this<br />
lever is determined by turning the lever in<br />
an "Electrical" control direction, manually<br />
at the A-end, as far as the lever can be<br />
moved.<br />
(3) The adjustable rod is to be lengthened or<br />
shortened, and as sembied to the brake release<br />
valve lever, and to the rocker shaft<br />
to maintain this position <strong>of</strong> the lever.<br />
(0) To adjust the venttn~ valve lever. -<br />
(1) Place the control selector lever in the "Electrical"<br />
control position.<br />
(2) The venting valve lever is to be moved manually<br />
at the A-end toward the mechanical position.<br />
The lever is then to be allowed to<br />
return to the electrical position by the<br />
spring action <strong>of</strong> the valve. The lever is<br />
to be moved approximately 1° farther ~n the<br />
"Electrical" control direction, and the adjustable<br />
rod is to be lengthened or shortened<br />
and assembled to the venting valve lever<br />
to maintain this position. The lever can<br />
be moved manually farther than the 1° past