OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER

'.,-
o
337
The brake cylinder is then to be secured to
the mounting base in the left hand position.
(j) The three ratchet dogs 274317-5 assembled to
the brake drum 274320-1 are to be dismantled,
by removing the slotted nuts 274339-7, and the
pins 274322-2. The ratchet dogs are to be
turned over and reassembled with the springs
274317-7 hooked over the opposite pins. For
convenience in changing the ratchet dogs the
brake drum may be removed from the drive shaft
and is to be replaced as soon as the change
is made.
(k) The brake band, lever and bracket assembly are
to be reassembled to theL.R. mounting position,
and are to be secured by the screws and
dowels. The brake band stop pins are to be
reassembled in their respective places and are
to be secured by the slotted nuts.
( Z) Before the hoisting drum can: be assembled it
will be necessary to form hooks of heavy wire,
which will hook into the spring retaining holes
of the ratchet dogs and hook over the edge of
the brake drum. These 'hooks are to be made
short enough to hold the' ratchet dogs clear
of the ratchet when the hoist drum is being
assembled. When the hoist dr-wmis far enough
on the shaft to permit the ratchet dogs to ride
on the ratchet, the wire hooks are to be removed
and the hoist drum slid completely on
the drive shaft.
(m) When the cam housing is ready for assembly
make sure that the spacer 274334-13 is assembled
into the bearing 274337-11 and into the
oil seal 274338-8 before sliding the cam housing
over the drive shaft. Also make sure that
the gasket 274329-4 is in place on the drive
shaft. Secure the housing to the base with
the dowels and screws provided. Reassemble
the spacer 274335-6, gear 274328-6, keys
200148-6, and the bearing lock, nuts and washers.
(n) The brake cylinder piston is to be reassembled
to the brake operating lever and the brake
band end is to be reassembled through the
block. The brake band is to be adjusted in
accordance with the adjustment instructions.