OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER
OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER
OP-755 Part 2 Pages 197-401 - Personal Page of GENE SLOVER
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
\ J<br />
229<br />
271721-4 and the loose keys 206693-5. Restrain lever<br />
271721-6 and cam 271721-5; then tap the end <strong>of</strong><br />
operating shaft 271721-1 until arm and cam become<br />
free.<br />
Remove screws 1968.25-6 and lock washers 196733-1.<br />
Shaft bracket 271722-1 can then be slipped <strong>of</strong>f dowels<br />
196700-8.<br />
Further dismantling <strong>of</strong> this unit is evident from the<br />
drawings.<br />
56. Disassemb ly <strong>of</strong> the B-end, (dr . 271678). - Due to<br />
the limited space it is necessary to move the entire unit to<br />
a portion <strong>of</strong> the proj ectile flat with available working space.<br />
In preparation for moving proceed as follows:-<br />
Drain the entire system by removing the drain plugs<br />
in the A and B-ends. Remove the external piping.<br />
Disconnect the couplings on the output and the worm<br />
wheel shafts, and remove the mounting bolts.<br />
57. Dismant ling the B-end. - 1-Jhencompletely dismantling<br />
the B-end a minimum <strong>of</strong> time will be required and trouble will<br />
be eliminated if the unit is dismantled according to the following<br />
instructions:<br />
Remove screws 206446-3 and cover 271697-3. Remove<br />
bearing housing 271696-1 and worm wheel 271697-1 as<br />
an assembly.<br />
Remove screws 206446-3 in control shaft bearing<br />
271697-8. Then remove bearing complete with shaft<br />
271694-2) oil seal 271730-4, spacer 271693-3, and<br />
lever 271692-7.<br />
Remove pilot bearing 271692-8. Shaft 271695-4 may<br />
be left assembled in place until yoke 271694-4 is<br />
removed from housing.<br />
Remove screws 180226-6 and retainer 271691-2 with<br />
oil seal 271730- 3. Remove bearing lock nut 271731-10<br />
and lock washer 271731-11.<br />
Remove screws 220678-3 in cylinder 271693-1. This<br />
cylinder with retainer 271691-1, screws 200075-6,<br />
bearing 271731-6, spacer 271688-4, piston 271694-1,<br />
spring 271694-3, bushing 271692-6 and end plate<br />
271695-7 with screws can be removed from the housing<br />
as an assembly. When these parts are removed the<br />
yoke 271694-4 and retainer spacer 271693-6 become<br />
free.