The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
15. Finally, log out of the admin console and restart the WebSphere server. For that, first stop the
server using the command ./stopServer.sh , and then, start it using the command
./startServer.sh . Both these commands are available in the /bin directory,
where is the install directory of the WebSphere server.
2.15.8.1 Enabling Performance Monitoring
To enable performance monitoring for the WebSphere server 5.0, do the following:
1. Open WebSphere’s admin console as explained in steps 1-3 of Section 3.3.2.
2. In the screen that appears (see Figure 2.110), expand the Servers node in the left pane, and click
on the Application Servers link within.
Figure 2.110: Viewing the list of application servers
3. As you can see, the right pane of Figure 2.110 displays the list of existing application servers.
Now, click on the server that has been configured for monitoring by eG as indicated by Figure
2.110.
4. From the list of options displayed in the right pane of Figure 2.111, select the Performance
Monitoring Service link.
135