The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
10. In case of Linux agents, the configuration process terminates after the Coldfusion server and
Sybase adaptive server configurations have been completed. If at a later stage, the user desires
to configure any Coldfusion servers for monitoring by the eG agent, the user need not start the
configuration process all over again. Instead, to configure a Coldfusion server, use the command
/opt/egurkha/bin/setup_cf. Similarly, for configuring a Sybase Adaptive server, use the command
/opt/egurkha/bin/setup_sybase.sh. Upon successful termination of the agent setup process, the
following message is displayed:
******************************************************************************
To configure any application at a later time for monitoring by the eG agent, please
follow the steps below:
- Database Servers: Configure database servers for monitoring by
the eG agent through the eG user interface.
- Coldfusion Servers: To configure a Coldfusion server for monitoring,
please have the Coldfusion server's
administrator execute the script
/opt/egurkha/bin/setup_cf.
- Sybase Adaptive Servers: To configure a Sybase Adaptive server for
monitoring, please have the Sybase server's
administrator execute the script
/opt/egurkha/bin/setup_sybase.sh
The eG Agent has been configured successfully.
Please use the commands /opt/egurkha/bin/start_agent and
/opt/egurkha/bin/stop_agent to start and stop the agent.
To provide feedback and report errors, please contact support@eginnovations.com
******************************************************************************
In case of Solaris agents, if you have chosen to configure a ColdFusion server, Sybase server, and
a web server for monitoring, then agent configuration ends only when all the three components
are properly configured. You can however, configure each of these servers at a later point of time
also, without reconfiguring the agent. To configure a Coldfusion server, use the command
/opt/egurkha/bin/setup_cf. Similarly, for configuring a Sybase Adaptive server, use the command
/opt/egurkha/bin/setup_sybase.sh. To configure the iPlanet/SunONE web server on the agent host,
then configure the web adapter using the command /opt/egurkha/bin/setup_webadapter.
To configure different applications at a later time
for monitoring by eG, please follow the steps below:
- Database Servers: Configure database servers for monitoring by
the eG Agent through the eG user interface.
- Web Servers: To configure any web servers running on sun08
for monitoring by the eG Agent, please have each of
the web server's administrators execute the script
/opt/egurkha/bin/setup_webadapter
This script will augment the web server's startup
files with eG monitoring capability.
- Coldfusion Servers: To configure a Coldfusion server for monitoring,
please have the Coldfusion server's administrator
execute the script
66