The eG Installation Guide - eG Innovations

Installing and Configuring on Windows Environments
3. Then, proceed to make the changes indicated in Bold below in the SSL XML block:
Set the port parameter in the XML block to reflect the port number that you have configured for
the eG manager. Also, note that two new parameters, namely - keystoreFile and keystorePass - have
been inserted into the SSL block. While the keystoreFile parameter has to be set to the full path to
the .keystore file that you generated earlier, the keystorePass parameter should be set to the
keystore password that you specified while issuing the keytool command.
4. With that change, the eG manager on Windows has acquired the capability to listen on two ports
- the SSL port and the non-SSL port. To configure the eG manager to listen only on the SSL port,
simply comment that section of the server.xml file where the non-SSL Coyote HTTP connector on
port 8081 has been defined, as indicated below:
5. Save the file.
6. Then, SSL-enable the start_manager.bat script. For this, first open the start_manager.bat file (see
Figure 1) residing in the \lib directory. Change the URL
http://:/final/servlet/upload present in the last line of the batch
file to https://:/final/servlet/upload (see Figure 1).
239