The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
Note:
We recommend that when you install the eG manager with an Oracle database
backend, the following tablespaces (with the parameters indicated) are specifically
created for eG:
create tablespace egurkhadata01
datafile 'C:\Oracle\ORADATA\egurkha\eGurkhaData01.dbf' size 10240M
autoextend off extent management local autoallocate;
create temporary tablespace egurkhatemp01
tempfile 'C:\Oracle\ORADATA\egurkha\eGurkhaTemp01.dbf' size 512M
autoextend off extent management local uniform;
Create rollback tablespaces and rollback segments as needed.
The usage of an Oracle backend for the eG manager also necessitates the resetting of
the following Oracle initialization parameters.
The processes parameter should be set to a minimum of 100
The open_cursors parameter should be set to a minimum of 200.
These parameters might have to be tuned further based on an increase in server load.
7. Database administrator privileges are required for creating a new database user. The setup now
prompts the user to enter the database administrator’s name and password.
New user creation requires database administrator privileges.
Enter the DBA user name :
Enter the DBA password :
8. Once the user account is created, the configuration process proceeds to create the various
database tables required by eG Enterprise. The following error message appears if the
configuration process does not succeed.
Database user creation started ...
Database user created successfully ...!
Configuration of the eG Manager continues...
****************************************************************
Attempting to load the eG tables into the database ...
If any error appears during the configuration, there may be a problem with the
Oracle database parameters you supplied. Please check and restart the manager
configuration.
Press to continue, to end
**************************************************************************
9. Upon successful installation of the manager, the following message will be displayed to the user:
******************************************************************************
If there were no errors, the eG Manager has been configured.
Please use the commands /opt/egurkha/bin/start_manager and
/opt/egurkha/bin/stop_manager to start and stop the manager.
You will need a valid license to start the eG Manager. Please contact
mailto:support@eginnovations.com to request for a license.
******************************************************************************
20