The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
Figure 2.18: Completing the install analysis process
6. Once the status becomes Completed, press Done.
7. Now, press Tab and choose File -> Exit to exit.
8. The install process will then prompt you to specify the name of the eG user.
Enter the name of the eG user [egurkha]: bob
9. Next, enter the path to the directory in which the eG agent is to be installed. The default base
directory for an eG agent is /opt. A subdirectory named egurkha will be created under this base
directory in the previous step.
Enter the directory in which the eG agent should be installed [/opt]:
10. Then, enter the name of the group with which the eG user is associated. If you specify an existing
user name, then this group prompt will not appear.
Enter the group to which the eG user is to be associated [egurkha]:
11. Would you like the eG agent to auto-restart on system boot-up? y/n [n]
The install process will now request the user to confirm installation of the auto-restart feature.
This feature will enable the agent to start automatically every time the system hosting the agent
reboots. Now, press y to install the auto-restart feature, or n to proceed without installing the
same.
12. Upon successful installation of the agent, the following message appears:
******************************************************
The eG agent has been successfully installed!
Please login as and run the script
/opt/egurkha/bin/setup_agent
to configure the agent.
******************************************************
51