The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
In the case of an iPlanet web server (prior to version 6.0), the start and stop files are modified after
retaining a copy of them called start.pre_egurkha and stop.pre_egurkha. To uninstall the web adapter
capability, replace the existing start and stop files with start.pre_egurkha and stop.pre_egurkha respectively.
2.14.2 Configuring the eG Web Adapter for a SunONE Web Server
Version 6.x on Solaris
To configure the eG web adapter for a SunONE web server version 6.x on Solaris, follow the steps
given below:
10. Login as a SunONE install user.
11. Open magnus.conf file in the //config/ directory. For instance, if
the SunONE web server is installed in the directory /opt/SUNWwbsvr, and the name of the server is
https-test, then the magnus.conf file will be in the directory: /opt/SUNWwbsvr/https-test/config directory.
Append the following lines in the file:
Init fn="load-modules" shlib="/opt/egurkha/lib/sun1webadapter_6.so" funcs="onServerInit,onChildInit,onLog"
Init fn="onServerInit" WEB_SERVER_ROOT=/
For example, if the SunONE web server is installed in the directory /opt/SUNWwbsvr, and the name
of the server is https-test, then you will have to append the following lines in the magnus.conf file:
Init fn="load-modules" shlib="/opt/egurkha/lib/sun1webadapter_6.so" funcs="onServerInit,onChildInit,onLog"
Init fn="onServerInit" WEB_SERVER_ROOT=/opt/SUNWwbsvr/https-test
12. Save the file.
13. Next, open the obj.conf file from the same location, and insert the following line as the last line of
the series that begins with the string, PathCheck fn:
PathCheck fn=”onChildInit”
Similarly, insert the following line as the last line of the series that begins with the string, AddLog
fn:
AddLog fn=”onLog”
14. Save the file.
15. Finally, restart the web server.
The web adapter for an Apache or an IBM HTTP web server, on the other hand, can be configured only
manually, and not through the eG agent setup procedure. The steps involved in the manual web
adapter configuration process have been detailed hereunder.
2.14.3 Configuring the eG Web Adapter for an Apache/IBM HTTP Web
Server on a 32-bit Unix Operating System
To manually configure the eG web adapter on an Apache web server 1.x on Unix, do the following:
1. First, login to the Unix server as the Apache install user.
2. Edit the /conf/httpd.conf file to append the following lines to the end of the file:
LoadModule eg1_module libexec/mod_eg1.so
3. Copy the file mod_eg1.so from the /opt/egurkha/lib directory to /libexec in the
directory.
4. Stop and restart the Apache server.
73