The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
Default value: 72000 milliseconds
Recommended value: 15000 milliseconds
Solaris TCP_KEEPALIVE_PROBES
Description:
Specifies the kernel how many TCP keepalive probes to send out before it decides if a specific
connection is broken.
How to view or set:
Use the ndd command to determine the current value or to set the value.
For example:
ndd -set /dev/tcp tcp_keepalive_probes 5000
Default value: 9000 milliseconds
Recommended value: 5000 milliseconds
Solaris kernel semsys:seminfo_semume
Description:
Limits the maximum semaphore undo entries per process. Because this setting specifies a
maximum value, the parameter does not cause the use of additional memory unless it is
needed.
How to view or set:
This value is displayed as the semume parameter if the /usr/sbin/sysdef command is run. There
can be an entry in the /etc/system file for this tuning parameter. Set this parameter through the
/etc/system entry:
set semsys:seminfo_semume = 200
Default value: 10
Recommended value: 200
Solaris kernel semsys:seminfo_semopm
Description:
10