The eG Installation Guide - eG Innovations

Installing and Configuring on Unix
6. Upon successful installation, a message to that effect will appear (see Figure 2.115). Now, click
on the Save to Master Configuration link in Figure 2.115. Consequently, Figure 2.116 will appear
wherein the Save button will have to be clicked in order to save the configuration changes to the
node manager.
Figure 2.116: Saving the configuration changes
7. Finally, log out of the admin console and restart the WebSphere server. For that, first stop the
server using the command ./stopServer.sh , and then, start it using the command
./startServer.sh . Both these commands are available in the /bin directory,
where is the install directory of the WebSphere server.
8. Then, proceed to enable performance monitoring for the application servers to be monitored
using the procedure discussed in Section 2.9.7.1 above.
2.15.10 SilverStream
No special configuring is necessary for SilverStream Application servers. To monitor them, the
appropriate SilverStream tests need to be configured. Please check the Measurements Manual for
details.
2.15.11 Configuring JRun Application Servers
2.15.11.1 Configuring a JRun Application Server 3.0
In order to configure a JRun application server for monitoring by an eG agent, you need to enable the
monitoring logs and configure the global.properties for customizing the output of the monitoring logs, by
following the steps given below:
139