TigerSwitch 10/100/1000 - SMC

SYSTEM MANAGEMENT COMMANDS
Command Usage
The logging process controls error messages to be sent to SNMP trap
receivers. You can use the logging history command to control the type
of error messages that are stored in memory and sent to a specified
SNMP trap receiver.
Example
Console(config)#logging on
Console(config)#
Related Commands
logging history
clear logging
logging history
Use this command to limit syslog messages sent to the Simple Network
Management Protocol network management station based on severity. The
no form returns the logging of syslog messages to the default level.
Syntax
logging history {flash | ram} level
no logging history {flash | ram}
• flash - Event history stored in Flash memory (i.e., permanent
memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
3-31