TigerSwitch 10/100/1000 - SMC

COMMAND LINE INTERFACE
bridge address
3-80
Use this command to map a static address to a port in a VLAN. Use the no
form to remove an address.
Syntax
bridge bridge-group address mac-address vlan vlan-id forward interface
[action]
no bridge bridge-group address address vlan vlan-id
• bridge-group - Bridge group index (bridge 1).
• mac-address - MAC address.
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
• action -
• delete-on-reset - Assignment lasts until switch is reset.
• permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port
within a specific VLAN. Use this command to add static addresses to
the MAC Address Table. Static addresses have the following
characteristics:
• Static addresses will not be removed from the address table when a
given interface link is down.