TigerSwitch 10/100/1000 - SMC

CONFIGURING THE SWITCH
Address Table Settings
2-30
Switches store the addresses for all known devices. This information is
used to route traffic directly between the inbound and outbound ports. All
the addresses learned by monitoring traffic are stored in the dynamic
address table. You can also manually configure static addresses that are
bound to a specific port.
Setting Static Addresses
A static address can be assigned to a specific interface on this switch. Static
addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be
ignored and will not be written to the address table.
Command Usage
Entries specified via the Web interface are permanent. Entries specified via
the CLI can be made permanent or can be set to be deleted on reset.
Web – Click Address Table/Static Addresses. Specify the interface, the
MAC address and VLAN, then click “Add Static Address.”