TigerSwitch 10/100/1000 - SMC

COMMAND LINE INTERFACE
3-72
Example
The following example configures port 11 to use autonegotiation.
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
capabilities
Use this command to advertise the port capabilities of a given interface
during autonegotiation. Use the no form with parameters to remove an
advertised capability, or the no form without parameters to restore the
default values.
Syntax
capabilities {1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric}
no port-capabilities [1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric]
• 1000full - Supports 1000 Mbps full-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 10half - Supports 10 Mbps half-duplex operation
• flowcontrol - Supports flow control
• symmetric - Transmits and receives pause frames for flow control
Default Setting
The default values for Gigabit Ethernet include all settings.
Command Mode
Interface Configuration (Ethernet, Port Channel)