TigerSwitch 10/100/1000 - SMC

COMMAND LINE INTERFACE
switchport mode
3-98
Use this command to configure the VLAN membership mode for a port.
Use the no form to restore the default.
Syntax
switchport mode {trunk | hybrid}
no switchport mode
• trunk - Specifies a port as an end-point for a VLAN trunk. A trunk
is a direct link between two switches, so the port transmits and
receives tagged frames that identify the source VLAN.
• hybrid - Keyword that specifies a hybrid VLAN interface. The port
may receive or transmit tagged or untagged frames. Any frames that
are not tagged will be assigned to the default VLAN.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command and the switchport acceptable-frame-types
command have the same effect.
Example
The following shows how to set the configuration mode to port 1, and
then set the switchport mode to hybrid:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
Related Commands
switchport acceptable-frame-types