TigerSwitch 10/100/1000 - SMC

More documents

Recommendations

Info

SWITCH MANAGEMENT 1-2 The switch’s CLI configuration program, Web interface, and SNMP agent allow you to perform the following management functions: • Set user names and passwords for up to 16 users • Set an IP interface for a management VLAN • Configure SNMP parameters • Enable/disable any port • Set the speed/duplex mode for any port • Configure up to 255 IEEE 802.1Q VLANs • Enable GVRP automatic VLAN registration • Configure IGMP multicast filtering • TFTP upload and download of system firmware • TFTP upload and download of switch configuration files • Configure Spanning Tree parameters • Configure Class of Service (CoS) priority queuing • Configure up to six static or LACP trunks • Enable jumbo frame support • Enable port mirroring • Set broadcast storm control on any port • Display system information and statistics
Required Connections CONNECTING TO THE SWITCH The switch provides an RS-232 serial port that enables a connection to a PC or terminal for monitoring and configuring the switch. A null-modem console cable is provided with the switch. Attach a VT100-compatible terminal, or a PC running a terminal emulation program to the switch. You can use the console cable provided with this package, or use a null-modem cable that complies with the wiring assignments shown in Appendix B. To connect a terminal to the console port, complete the following steps: 1. Connect the console cable to the serial port on a terminal, or a PC running terminal emulation software, and tighten the captive retaining screws on the DB-9 connector. 2. Connect the other end of the cable to the RS-232 serial port on the switch. 3. Make sure the terminal emulation software is set as follows: • Select the appropriate serial port (COM port 1 or COM port 2). • Set the data rate to 9600 baud. • Set the data format to 8 data bits, 1 stop bit, and no parity. • Set flow control to none. • Set the emulation mode to VT100. • When using HyperTerminal, select Terminal keys, not Windows keys. Note: When using HyperTerminal with Microsoft ® Windows ® 2000, make sure that you have Windows 2000 Service Pack 2 or later installed. Windows 2000 Service Pack 2 fixes the problem of arrow keys not functioning in HyperTerminal’s VT100 emulation. See www.microsoft.com for information on Windows 2000 service packs. 1-3
Page 1: TigerSwitch 10/100/1000 Gigabit Eth
Page 4 and 5: Information furnished by SMC Networ
Page 6 and 7: LIMITED WARRANTY ii LIABILITY IN CO
Page 8 and 9: CONTENTS iv Configuring Interface C
Page 10 and 11: CONTENTS vi boot system . . . . . .
Page 12 and 13: CONTENTS viii bridge priority . . .
Page 14 and 15: CONTENTS APPENDICES: A Troubleshoot
Page 18 and 19: SWITCH MANAGEMENT 1-4 4. Once you h
Page 20 and 21: SWITCH MANAGEMENT 1-6 Passwords can
Page 22 and 23: SWITCH MANAGEMENT 1-8 4. To set the
Page 24 and 25: SWITCH MANAGEMENT 1-10 Community St
Page 26 and 27: SWITCH MANAGEMENT Managing System F
Page 28 and 29: SWITCH MANAGEMENT 1-14 Function Par
Page 30 and 31: SWITCH MANAGEMENT 1-16
Page 32 and 33: CONFIGURING THE SWITCH 2-2 3. After
Page 34 and 35: CONFIGURING THE SWITCH 2-4 Notes: 1
Page 36 and 37: CONFIGURING THE SWITCH 2-6 Menu Add
Page 38 and 39: CONFIGURING THE SWITCH Basic Config
Page 40 and 41: CONFIGURING THE SWITCH Setting the
Page 42 and 43: CONFIGURING THE SWITCH 2-12 Web - C
Page 44 and 45: CONFIGURING THE SWITCH Configuring
Page 46 and 47: CONFIGURING THE SWITCH Managing Fir
Page 48 and 49: CONFIGURING THE SWITCH Saving or Re
Page 50 and 51: CONFIGURING THE SWITCH Copying the
Page 52 and 53: CONFIGURING THE SWITCH 2-22 CLI - E
Page 54 and 55: CONFIGURING THE SWITCH Port Configu
Page 56 and 57: CONFIGURING THE SWITCH Configuring
Page 58 and 59: CONFIGURING THE SWITCH Setting Broa
Page 60 and 61: CONFIGURING THE SWITCH Address Tabl
Page 62 and 63: CONFIGURING THE SWITCH 2-32 For exa
Page 64 and 65: CONFIGURING THE SWITCH 2-34 The fol
Page 66 and 67:
CONFIGURING THE SWITCH 2-36 CLI - T
Page 68 and 69:
CONFIGURING THE SWITCH 2-38 • Dis
Page 70 and 71:
CONFIGURING THE SWITCH 2-40 Web - C
Page 72 and 73:
CONFIGURING THE SWITCH 2-42 VLANs h
Page 74 and 75:
CONFIGURING THE SWITCH 2-44 To impl
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
CONFIGURING THE SWITCH Adding Inter
Page 82 and 83:
CONFIGURING THE SWITCH 2-52 • GVR
Page 84 and 85:
CONFIGURING THE SWITCH Setting the
Page 86 and 87:
CONFIGURING THE SWITCH 2-56 to reco
Page 88 and 89:
CONFIGURING THE SWITCH Setting the
Page 90 and 91:
Page 92 and 93:
CONFIGURING THE SWITCH Mapping DSCP
Page 94 and 95:
CONFIGURING THE SWITCH Port Trunk C
Page 96 and 97:
CONFIGURING THE SWITCH Statically C
Page 98 and 99:
Page 100 and 101:
CONFIGURING THE SWITCH 2-70 The pur
Page 102 and 103:
Page 104 and 105:
CONFIGURING THE SWITCH 2-74 (port o
Page 106 and 107:
CONFIGURING THE SWITCH Adding Multi
Page 108 and 109:
CONFIGURING THE SWITCH 2-78 passing
Page 110 and 111:
CONFIGURING THE SWITCH 2-80
Page 112 and 113:
COMMAND LINE INTERFACE 3-2 After co
Page 114 and 115:
COMMAND LINE INTERFACE 3-4 You can
Page 116 and 117:
COMMAND LINE INTERFACE 3-6 between
Page 118 and 119:
COMMAND LINE INTERFACE Configuratio
Page 120 and 121:
COMMAND LINE INTERFACE Command Grou
Page 122 and 123:
COMMAND LINE INTERFACE General Comm
Page 124 and 125:
COMMAND LINE INTERFACE 3-14 Example
Page 126 and 127:
COMMAND LINE INTERFACE end exit 3-1
Page 128 and 129:
COMMAND LINE INTERFACE Flash/File C
Page 130 and 131:
COMMAND LINE INTERFACE delete 3-20
Page 132 and 133:
COMMAND LINE INTERFACE 3-22 • Fil
Page 134 and 135:
Page 136 and 137:
COMMAND LINE INTERFACE username 3-2
Page 138 and 139:
COMMAND LINE INTERFACE 3-28 Command
Page 140 and 141:
COMMAND LINE INTERFACE ip http serv
Page 142 and 143:
COMMAND LINE INTERFACE 3-32 • lev
Page 144 and 145:
COMMAND LINE INTERFACE 3-34 Default
Page 146 and 147:
COMMAND LINE INTERFACE show running
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
COMMAND LINE INTERFACE SNMP Command
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
COMMAND LINE INTERFACE 3-52 separat
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
COMMAND LINE INTERFACE line 3-58 Us
Page 170 and 171:
COMMAND LINE INTERFACE password 3-6
Page 172 and 173:
COMMAND LINE INTERFACE password-thr
Page 174 and 175:
COMMAND LINE INTERFACE databits 3-6
Page 176 and 177:
COMMAND LINE INTERFACE stopbits 3-6
Page 178 and 179:
COMMAND LINE INTERFACE Interface Co
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
COMMAND LINE INTERFACE shutdown 3-7
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
COMMAND LINE INTERFACE bridge addre
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
COMMAND LINE INTERFACE bridge forwa
Page 198 and 199:
COMMAND LINE INTERFACE 3-88 • The
Page 200 and 201:
Page 202 and 203:
COMMAND LINE INTERFACE show bridge
Page 204 and 205:
COMMAND LINE INTERFACE VLAN Command
Page 206 and 207:
COMMAND LINE INTERFACE vlan 3-96 Us
Page 208 and 209:
COMMAND LINE INTERFACE switchport m
Page 210 and 211:
COMMAND LINE INTERFACE switchport i
Page 212 and 213:
COMMAND LINE INTERFACE switchport a
Page 214 and 215:
COMMAND LINE INTERFACE show vlan 3-
Page 216 and 217:
COMMAND LINE INTERFACE 3-106 Comman
Page 218 and 219:
COMMAND LINE INTERFACE 3-108 Note:
Page 220 and 221:
COMMAND LINE INTERFACE 3-110 Exampl
Page 222 and 223:
COMMAND LINE INTERFACE ip igmp snoo
Page 224 and 225:
COMMAND LINE INTERFACE 3-114 Comman
Page 226 and 227:
COMMAND LINE INTERFACE ip igmp snoo
Page 228 and 229:
COMMAND LINE INTERFACE 3-118 Relate
Page 230 and 231:
COMMAND LINE INTERFACE show ip igmp
Page 232 and 233:
COMMAND LINE INTERFACE switchport p
Page 234 and 235:
COMMAND LINE INTERFACE 3-124 Relate
Page 236 and 237:
Page 238 and 239:
COMMAND LINE INTERFACE 3-128 • co
Page 240 and 241:
COMMAND LINE INTERFACE 3-130 • co
Page 242 and 243:
COMMAND LINE INTERFACE show map ip
Page 244 and 245:
COMMAND LINE INTERFACE 3-134 • Th
Page 246 and 247:
COMMAND LINE INTERFACE channel-grou
Page 248 and 249:
Page 250 and 251:
TROUBLESHOOTING Upgrading Firmware
Page 252 and 253:
TROUBLESHOOTING A-4 If using Window
Page 254 and 255:
TROUBLESHOOTING A-6
Page 256 and 257:
PIN ASSIGNMENTS Console Port to 9-P
Page 258 and 259:
GLOSSARY Collision Domain CSMA/CD G
Page 260 and 261:
GLOSSARY IEEE 802.3 Defines carrier
Page 262 and 263:
GLOSSARY Multicast Switching A proc
Page 264 and 265:
GLOSSARY Glossary-8
Page 266:
INDEX R RADIUS, logon authenticatio
show all

TigerSwitch 10/100/1000 - SMC

Create successful ePaper yourself

Delete template?

Save as template?