TigerSwitch 10/100/1000 - SMC

CONFIGURING THE SWITCH
2-32
For example, the following screen shows the dynamic addresses for port 7.
CLI – This example also displays the address table entries for port 11.
Console#show bridge 1 ethernet 1/11 3-81
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/11 00-10-b5-62-03-74 1 Learned
Console#
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Usage
The range for the aging time is 17 - 2184 seconds. (The default is 300
seconds.)
Web – Click Address Table/Address Aging. Specify the new aging time,
then click “Apply.”
CLI – This example sets the aging time to 400 seconds.
Console(config)#bridge-group 1 aging-time 400 3-83
Console(config)#