TigerSwitch 10/100/1000 - SMC

MANAGING FIRMWARE
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
Console#copy tftp startup-config 3-18
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
/
Console#
Setting the Startup Configuration File
If you download to a new file name, then select the new file from the
drop-down box, and click “Apply Changes.”
To use the new settings, reboot the system.
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
Console#copy tftp startup-config 3-18
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
/
Console#
Console#config
Console(config)#boot system config: startup2.0 3-23
Console(config)#exit
Console#reload
Note: The CLI allows you replace a running configuration file without
performing a reset.
2-19