TigerSwitch 10/100/1000 - SMC

COMMAND LINE INTERFACE
ip igmp snooping query-count
3-116
Use this command to configure the query count. Use the no form to
restore the default.
Syntax
ip igmp snooping query-count count
no ip igmp snooping query-count
count - The maximum number of queries issued for which there has
been no response before the switch takes action to solicit reports.
(Range: 2-10)
Default Setting
2 times
Command Mode
Global Configuration
Example
The following shows how to configure the query count to 10:
Console(config)#ip igmp snooping query-count 10
Console(config)#
ip igmp snooping query-interval
Use this command to configure the snooping query interval. Use the no
form to restore the default.
Syntax
ip igmp snooping query-interval seconds
no ip igmp snooping query-interval
seconds - The frequency at which the switch sends IGMP host-query
messages. (Range: 60-125)
Default Setting
125 seconds