TigerSwitch 10/100/1000 - SMC

Command Mode
Normal Exec, Privileged Exec
Example
ADDRESS TABLE COMMANDS
This example shows the configuration setting for Ethernet port 15.
Console#show interfaces switchport ethernet 1/15
Information of Eth 1/15
broadcast threshold: Enabled, 256 packets/second
Lacp status: Disabled
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Enabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#
Address Table Commands
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
Command Function Mode Page
bridge address Maps a static address to a port in a VLAN GC 3-80
show bridge Displays classes of entries in the
bridge-forwarding database
PE 3-81
clear bridge Removes any learned entries from the
forwarding database and clears the transmit and
receive counts for any statically or system
configured entries
PE 3-82
bridge-group
aging-time
show bridge
aging-time
Sets the aging time of the address table GC 3-83
Shows the aging time for the address table PE 3-83
3-79