TigerSwitch 10/100/1000 - SMC

System Defaults
SYSTEM DEFAULTS
The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file
should be set as the startup configuration file. See “Setting the Startup
Configuration File” on page 2-19.
The following table lists some of the basic system defaults.
Function Parameter Default
IP Settings Management VLAN 1
DHCP Enabled
BOOTP Disabled
User Specified Disabled
IP Address 0.0.0.0
Subnet Mask 255.0.0.0
Default Gateway 0.0.0.0
Web Management HTTP Server Enabled
HTTP Port Number 80
SNMP Community Strings “public” (read only)
“private” (read/write)
Authentication Failure
Traps
Enabled
Link-up-Down Traps Enabled
Security Privileged Exec Level Username “admin”
Password “admin”
Normal Exec Level Username “guest”
Password “guest”
Enable Privileged Exec
from Normal Exec Level
Password “super”
RADIUS Authentication Disabled
1-13