TigerSwitch 10/100/1000 - SMC

COMMAND LINE INTERFACE
3-118
Related Commands
ip igmp snooping version
ip igmp snooping query-time-out
Use this command to configure the snooping query-timeout. Use the no
form of this command to restore the default.
Syntax
ip igmp snooping query-time-out seconds
no ip igmp snooping query-time-out
seconds - The time the switch waits after the previous querier has
stopped querying before it takes over as the querier. (Range:
300-500)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must be using IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping query-time-out 300
Console(config)#
Related Commands
ip igmp snooping version