Programming manual M238 | 3 MB - BERGER - POSITEC

AS-Interface Configuration
Step Action
6 Click on the Copy to project button.
The Copy to project function allows you to copy a slave detected on the network
to the project Device tree. You can select several slaves using SHIFT+click, then
use the Copy to project button to copy all selected devices to the project Device
tree. Slaves with the same address will be overwritten
Your project is now updated with all connected slave devices under the Device
tree. You need to download the application again to make these changes
operational.
7 If you want to add another AS-Interface slave, connect it to your Fieldbus and
run a new scan (Step 3).
Manually Add a Generic Slave Device
If you want to manually configure your AS-Interface Slave device, you can add a
generic AS-Interface Slave and configure its profile.
This procedure is similar to the catalog method, but in this case you must choose a
special device from the list.
The procedure shows you how to add generic slave devices to your project:
Step Action
1 Go to the Program menu of SoMachine:
106 EIO0000000384 04/2012