Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Updating the Controller Firmware<br />
Updating Through Serial Line<br />
Introduction<br />
The firmware update through serial line (see page 124) is not available for all <strong>M238</strong><br />
Product Versions:<br />
Controller Reference Update through Serial Link Availability<br />
T<strong>M238</strong>LDD24DT Product Version (PV) < 08<br />
T<strong>M238</strong>LFDC24DT Product Version (PV) < 08<br />
T<strong>M238</strong>LFDC24DTSO Product Version (PV) < 02<br />
T<strong>M238</strong>LDA24DR No serial line update<br />
T<strong>M238</strong>LFAC24DR No serial line update<br />
Performing a firmware update will delete the current application program in the<br />
device, including the Boot Application in Flash memory.<br />
LOSS OF APPLICATION DATA<br />
CAUTION<br />
Perform a backup of the application program to the hard disk of the PC before<br />
attempting a firmware update.<br />
Restore the application program to the device after a successful firmware<br />
update.<br />
Failure to follow these instructions can result in injury or equipment damage.<br />
If there is a power outage or communication interruption during the transfer of the<br />
application program or a firmware update, your device may become inoperative. If<br />
a communication interruption or a power outage occurs, reattempt the transfer.<br />
INOPERABLE EQUIPMENT<br />
NOTICE<br />
Do not interrupt the transfer of the application program or a firmware update<br />
once the transfer has begun.<br />
Do not place the device into service until the transfer has completed<br />
successfully.<br />
Failure to follow these instructions can result in equipment damage.<br />
182 EIO0000000384 04/2012
Change language