Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Step Action Comment<br />
3 Enter the valid Subnet mask assigned to<br />
the gateway by your network administrator.<br />
Please note that you cannot leave this field<br />
blank; you must enter a value.<br />
(See notes 1 and 3.)<br />
4 Enter the IP address of the Gateway.<br />
(See notes 1 and 4.)<br />
5 Check and validate your configuration. -<br />
6 Power off the Controller, then power on<br />
again.<br />
Ethernet/Modbus Gateway<br />
By default, the programming software automatically<br />
computes and displays a default subnet mask based on<br />
the network class that you have provided in the IP Address<br />
field above. Default subnet mask values, according to the<br />
category of the gateway network IP address, follow these<br />
rules:<br />
Class A network -> Default subnet mask: 255.0.0.0<br />
Class B network -> Default subnet mask: 255.255.0.0<br />
Class C network -> Default subnet mask: 255.255.255.0<br />
On the LAN, the gateway must be on the same segment as<br />
the 499TWD01100. This information typically is provided to<br />
you by your network administrator. Please note that no<br />
default value is provided by the application, and that you<br />
must enter a valid gateway address in this field.<br />
A power cycle is required to force the <strong>M238</strong> to transfer the<br />
IP address to the 499TWD01100.<br />
NOTE:<br />
1. Consult your network or system administrator to obtain valid IP parameters for<br />
your network.<br />
2. Each connected device on an Ethernet network segment must have a unique IP<br />
address. When connected to the network, the gateway runs a check for duplicate<br />
IP address. If a duplicate IP address is located over the network, the STATUS<br />
LED will emit 4 flashes periodically. You must then enter a new duplicate-free IP<br />
address in this field.<br />
3. Unless the gateway has special subnet requirements, use the default subnet<br />
mask.<br />
4. If there is no gateway device on your network, simply enter the gateway’s IP<br />
address in the Gateway Address field.<br />
EIO0000000384 04/2012 153