Programming manual M238 | 3 MB - BERGER - POSITEC

Step 4 - Transfer Progress
Overview
In this screen you can monitor the transfer progress.
The remaining time information is available after a while.
Updating the Controller Firmware
If Transfer is Successful
If the transfer is successful, a message box is displayed to allow for another transfer.
Two options are available:
Yes - the wizard returns to Step 2 - Settings (see page 189) and you can set up
another transfer.
No - click on the Close button to exit the wizard. This completes the update
procedure.
If Transfer is not Successful
If the transfer is interrupted (for example, due to a loss of communication), a
message box is displayed allowing a retry of the transfer. Two options are available:
Yes - the wizard returns to Step 3 - Files and Device Exec Properties
(see page 191) and you can try another transfer.
No - click on the Close button to exit the wizard.
Your controller remains inoperative until a successful transfer has been
accomplished.
INOPERABLE EQUIPMENT
NOTICE
Do not interrupt the transfer of the application program or a firmware update
once the transfer has begun.
Do not place the device into service until the transfer has completed
successfully.
Failure to follow these instructions can result in equipment damage.
EIO0000000384 04/2012 193