Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Loader Device Accessory<br />
Set the Controller to RUNNING State<br />
Procedure<br />
UNINTENDED EQUIPMENT OPERATION<br />
WARNING<br />
You must have operational knowledge of your machine or process before<br />
connecting this device to your controller.<br />
Be sure that your machine or process is in a know safe state (STOP,<br />
SHUTDOWN, INERT, etc.) before transitioning the Loader Device Accessory to<br />
the “On” switch position while connected to your controller.<br />
Be sure that guards are in place so that any potential unintended equipment<br />
operation will not cause injury to personnel or damage to equipment.<br />
You must have read and understood the user documentation of this and other<br />
devices involved in the functions performed by the Loader Device Accessory.<br />
Failure to follow these instructions can result in death, serious injury, or<br />
equipment damage.<br />
The following procedure describes how to set a controller to RUNNING state using<br />
the Loader Device Accessory.<br />
Step Action<br />
1 Disconnect the USB key from the Loader Device Accessory.<br />
2 Connect the Loader Device Accessory to the controller.<br />
3 Move the Loader Device Accessory On/Off switch to the On position.<br />
NOTE: The controller is set in RUNNING state.<br />
4 Move the Loader Device Accessory On/Off switch to the Off position.<br />
5 Disconnect the Loader Device Accessory from the controller.<br />
The Loader Device Accessory is automatically switched off<br />
after 10 s, if the update has been successfully completed.<br />
after 60 s, if the update has been unsuccessful.<br />
178 EIO0000000384 04/2012
Change language