Programming manual M238 | 3 MB - BERGER - POSITEC

The following table describes the data of the structure:
Address Item Description
1 Input/output
data
AS-Interface Configuration
Input data is stored by the slave and made available for the
AS-Interface master.
Output data is updated by the master module.
2 Parameters The parameters are used to control and switch internal
operating modes to the sensor or the actuator.
3 Configuration/
Identification
This field contains:
the I/O configuration code (IO code)
the slave identification code (ID code)
the slave extended identification codes (ID1 and ID2 codes)
4 Address Physical address of slave.
Note: The operating parameters, address, configuration and identification data are saved in
a non-volatile memory.
EIO0000000384 04/2012 93