Programming manual M238 | 3 MB - BERGER - POSITEC

Ethernet/Modbus Gateway
Configuring the 499TWD01100 Ethernet Gateway Module
You must carefully manage the IP addresses because each device on the network
requires a unique address. Having multiple devices with the same IP address can
cause unpredictable operation of your network and associated equipment.
UNINTENTED EQUIPMENT OPERATION
WARNING
Be sure that there is only one master controller configured on the network or
remote link.
Be sure that all devices have unique addresses.
Obtain your IP address from your system administrator.
Confirm that the device’s IP address is unique before placing the system into
service.
Do not assign the same IP address to any other equipment on the network.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
To configure Ethernet parameters, follow this procedure:
Step Action Comment
1 Double click the 499TWD01100 node to
access the configuration window.
2 Enter the static IP Address for the gateway
in dotted decimal notation.
(See notes 1 and 2.)
The Ethernet Configuration dialog box appears, as
shown in the example below.
-
152 EIO0000000384 04/2012