Programming manual M238 | 3 MB - BERGER - POSITEC

Loader Device Accessory
Functionalities
The Loader Device Accessory can be used in the following cases:
Upload from SoMachine to the USB memory key (see page 171)
Upload from the controller to the USB memory key (see page 173)
Download from the USB memory key to the controller (see page 174)
Set the controller to RUNNING state (see page 178)
Update the firmware of the Loader Device Accessory (see page 179)
UNINTENDED EQUIPMENT OPERATION
WARNING
You must have operational knowledge of your machine or process before
connecting this device to your controller.
Be sure that your machine or process is in a know safe state (STOP,
SHUTDOWN, INERT, etc.) before transitioning the Loader Device Accessory to
the “On” switch position while connected to your controller.
Be sure that guards are in place so that any potential unintended equipment
operation will not cause injury to personnel or damage to equipment.
You must have read and understood the user documentation of this and other
devices involved in the functions performed by the Loader Device Accessory.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
164 EIO0000000384 04/2012