Programming manual M238 | 3 MB - BERGER - POSITEC

Upload From the Controller to the USB Memory Key
Procedure
UNINTENDED EQUIPMENT OPERATION
WARNING
Loader Device Accessory
You must have operational knowledge of your machine or process before
connecting this device to your controller.
Be sure that your machine or process is in a know safe state (STOP,
SHUTDOWN, INERT, etc.) before transitioning the Loader Device Accessory to
the “On” switch position while connected to your controller.
Be sure that guards are in place so that any potential unintended equipment
operation will not cause injury to personnel or damage to equipment.
You must have read and understood the user documentation of this and other
devices involved in the functions performed by the Loader Device Accessory.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
The following procedure describes how to upload on your USB memory key the
current project stored in the controller:
Step Action
1 Remove any file from the root of your USB memory key.
If there is a controller pair of files in the USB memory key, the download (see page 174) function starts
automatically.
2 Power on your controller.
3 Connect the USB memory key to the Loader Device Accessory.
4 Connect the Loader Device Accessory to the controller with USB cable.
5 Move the Loader Device Accessory On/Off switch to the On position.
NOTE: The controller is set to STOPPED state.
6 Wait for the files to be uploaded on the USB memory key. (LED (see page 167) at Normal operation state).
7 At the end of the upload (LED (see page 167) at Operation complete state), move the Loader Device
Accessory On/Off switch to the Off position.
8 Disconnect the Loader Device Accessory from the controller.
9 Disconnect the USB memory key and the USB cable from the Loader Device Accessory.
10 Execute a Run command (see page 57) or use the Set the controller to RUNNING state (see page 178)
feature to set the controller to RUNNING state.
The Loader Device Accessory is automatically switched off
after 10 s, if the upload has been successfully completed.
after 60 s, if the upload has been unsuccessful.
EIO0000000384 04/2012 173