Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
Programming manual M238 | 3 MB - BERGER - POSITEC
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Updating Through USB<br />
Introduction<br />
Updating the Controller Firmware<br />
The firmware update through USB Link is not available for all <strong>M238</strong> Product<br />
Versions:<br />
Controller Reference Update through USB Availability<br />
T<strong>M238</strong>LDD24DT Product Version (PV) >= 08<br />
T<strong>M238</strong>LFDC24DT Product Version (PV) >= 08<br />
T<strong>M238</strong>LFDC24DTSO Product Version (PV) >= 02<br />
T<strong>M238</strong>LDA24DR All versions<br />
T<strong>M238</strong>LFAC24DR All versions<br />
Performing a firmware update will delete the current application program in the<br />
device, including the Boot Application in Flash memory.<br />
LOSS OF APPLICATION DATA<br />
CAUTION<br />
Perform a backup of the application program to the hard disk of the PC before<br />
attempting a firmware update.<br />
Restore the application program to the device after a successful firmware<br />
update.<br />
Failure to follow these instructions can result in injury or equipment damage.<br />
If there is a power outage or communication interruption during the transfer of the<br />
application program or a firmware update, your device may become inoperative. If<br />
a communication interruption or a power outage occurs, reattempt the transfer.<br />
INOPERABLE EQUIPMENT<br />
NOTICE<br />
Do not interrupt the transfer of the application program or a firmware update<br />
once the transfer has begun.<br />
Do not place the device into service until the transfer has completed<br />
successfully.<br />
Failure to follow these instructions can result in equipment damage.<br />
EIO0000000384 04/2012 185
Change language