Programming manual M238 | 3 MB - BERGER - POSITEC

Loader Device Accessory
16.2 Upload From SoMachine to the USB Memory Key
Transfer From SoMachine to the USB Memory Key
Procedure
The following procedure describes how you can create the necessary files for
download to a controller with a USB memory key.
Step Action
1 Open or create the project you want to transfer with the USB memory key using
SoMachine.
2 Connect your USB memory key to your computer.
NOTE: The USB memory key must be empty.
3 Select in the menu Online → Create Boot Application.
NOTE: SoMachine must be running in offline mode to be able to execute this
command.
4 Define your project name and save it in the root of the USB memory key.
NOTE: Save the files in the root of the USB memory key. Otherwise they will
not be detected by the Loader Device Accessory.
NOTE: Only save one project on the USB memory key.
NOTE: If your project was created with a version of SoMachine inferior to version
3.1, or created in a context of a version less than 3.1, refer to the SoMachine
software compatibility (see page 169) for important information.
EIO0000000384 04/2012 171